1/24 Scale Herringbone Brick Latex Sheet

Add a new dimension to your miniature build with our Herringbone brick pattern sheets. Although these latex Herringbone brick veneer sheets are technically 1/24 scale, our incredibly talented staff miniaturist, Fran, highly recommends them for use in a variety of 1/12 scale scenes. "Because of the herringbone brick pattern and irregular shape and size of the bricks, it is almost better in 1/12 than 1/24."

Here are some suggested uses:

• An outdoor patio or garden walkway
• A hearth or fireplace interior
• An 'Old World' kitchen floor
• As accent panels in a chimney
• In a Tudor-styled structure filling some panels on a beam & stucco exterior

The rubber-like composition of this faux stone, Herringbone brick sheet makes it easy to apply leaving no wrinkles or gaps. It is easily cut with scissors or a craft knife.

New and Improved Installation Instructions
Paint the entire back of the sheet with a coat of Gesso #55309. Use a brush that leaves marks; let dry. Apply Grandmother Stover’s Glue #172 (or similar adhesive) very thinly, using an old credit card or similar, to the surface where the sheet will go. Put the sheet in place, trying not to stretch or distort it in any way. Do not rub, but use pressure to assure good adhesion, especially in the center area. If it is on a surface that must remain vertical during installation, use masking tape to hold it in place while the glue dries completely (at least 24-48 hours). If the surface will be painted, prime with Gesso before using craft acrylics.

11" x 17"

Scale: 1/24
Assembly Required: No
Item may vary slightly from the image shown

1/24 scale, also referred to as half-inch scale (or 1/2" scale), means 1/2 inch = 1 foot