Common Brick Latex Sheet

The rubber-like composition of this brick latex makes it easy to apply—and with no wrinkles or gaps. Can be painted with acrylics. The brick pattern sheet runs horizontally 17" and are approximately 5/8"W X 1/4"H.

New and Improved Installation Instructions
Paint the entire back of the sheet with a coat of Gesso #55308. Use a brush that leaves marks; let dry. Apply Grandmother Stover’s Glue #172 (or similar adhesive) very thinly, using an old credit card or similar, to the surface where the sheet will go. Put the sheet in place, trying not to stretch or distort it in any way. Do not rub, but use pressure to assure good adhesion, especially in the center area. If it is on a surface that must remain vertical during installation, use masking tape to hold it in place while the glue dries completely (at least 24-48 hours). If the surface will be painted, prime with Gesso before using craft acrylics.

We recommend using Quick Grip Glue to adhere these bricks.

One 11" x 17" sheet

Scale: 1/12
Assembly Required: No
Item may vary slightly from the image shown

1/12 scale, also referred to as one-inch scale (or 1" scale), means 1 inch = 1 foot